![]() It’s a little more inconvenient, but you’ll be switching batteries less often. ![]() If you’re doing outdoor work on a heated building, go ahead and put your batteries and charger inside. Set them in the sun.Įxactly the opposite of what you do in high temperatures, but setting the battery and charger where it gets direct sunlight will raise the temperature more than sitting in the shade. Allowing them to warm up on the way will help them deliver additional power and run time. Bring the batteries you’ll be using inside and point a vent near them. I know you’re running the heat in your truck on the way to the job site. When the temperatures drop, here are a few maintenance tips to warm them up some. Lithium-ion Battery Maintenance Tip #2: Cold Temperaturesīatteries need to be not too hot, but also not too cold to perform at their best. Find a place to store and charge those batteries inside if your spouse lets you. Opening the garage door helps some, but it’s not as nice as being in the air-conditioned house. Where I live, you start sweating as soon as you step foot in the garage. Help maintain productivity by giving the tool frequent breaks in aggressive applications like demo work and concrete drilling. You’ll feel the temperature rising on the tool as it gets to the auto shut off point. Likewise, if you’re taking even a short break from using the tool, set it in the shade until it’s needed again. While not as extreme as being inside a vehicle, simply sitting in the sunshine will elevate the temperature as well. Storing your batteries there will have temperatures at over 100 degrees before you even turn the tool on. Temperatures in the bed of your truck and inside your truck can skyrocket compared to the ambient temperature of the air. In hot weather conditions, keep your batteries in a cool, shaded area. ![]() Give it the benefit of cooling down for just a couple of minutes before putting it back under load. Even just sitting on a plugged-in charger generates a little bit of additional heat. If you pull the battery off right at the end of the cycle, there will be some leftover heat. Most chargers have an auto shut-off to stop the charging process when it reaches full. Take your battery off the charger and let it cool for a few minutes before putting it back in use.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |